6. In the
PLC/Controller Address
frame, enter the PLC coil or register address. Or click the
PLC/Controller Address button
to display the Edit PLC/Controller Address dialog box:
Check the
Memory Area
box. Click the pull-down box to select the
target PLC memory area
. Use
the numeric keypad to enter the specific
PLC memory address
. Select the
PLC Network Address
(if
applicable) and
HMI communications port
. Click
Enter
to go back to prior dialog box.
7. Click the
Font
button to select the
font
that will be used for any text labels created for each state in the
Show State Table
.
8
Click the
Show State Table
button to display the States Table dialog box:
9. For each State, enter the
Range Limit
which determines if that state’s bitmap or text label is to be
displayed. The range limit number entered must be larger than the prior state and smaller than each
successive state, as shown in the example above. You can also click the
Range Calculator
button to
display the Range Calculator:
The Range Calculator is a tool to help you easily determine the ranges. By setting the minimum value
to be represented (lower boundary) and maximum value to be represented (upper boundary), the
calculator will evenly divide the range for each state. Click the
Set
button to go back to the prior dialog
box.
1010-0300, Rev 02
88
Blue Series Installation & Operation Manual
