7. Click
Tools…Write Project to BLU300
.
8. On the BLU300, power up the OIT and hold down the ESC key during power-up. The BLU300 will
eventually beep and display the following setup screen:
9. Press the
F1
key to move the block cursor to
1. Read from PC
, and then press the ENTER key on
the BLU300. The BLU300 will display a screen indicating that it is waiting for communications to be
established with the BlueLeaf software.
10. Click
Yes
on the Confirm dialog box in BlueLeaf to commence the download process. After the
project transmission is complete, a new dialog box is displayed. Click
OK
to complete the download.
On the BLU300 OIT, you should see a new screen that indicates the download process is finished.
Press the ESC key to exit the download screen and display the Setup screen again.
11. Press the
F5
key to move the block cursor on the BLU300 OIT to
5.EXIT & RUN
, then press the
ENTER key after you have connected your PLC to the BLU300. The startup screen listed above
should appear.
12. Press the
F2
key to initiate the Numeric Entry process. The Numeric Entry screen should appear on
the BLU300:
13. The Numeric Entry screen displays the minimum and maximum allowed values at the top of the screen
(in this example- Min:100 Max:1000). In the center of the screen, the current value of the PLC
register is displayed (note: if you checked the Read checkbox during configuration of the Numeric
Input object, then the HMI will show the latest value of the Read register).
14. To enter a new number into the Numeric Entry screen, you must highlight each digit of the number
using the blinking block cursor. Once selected, each digit can be changed one of two ways: 1) by
pressing the UP/DOWN keys of the BLU300 or 2) by pressing one of the function keys (F1-F5). After
you have changed the digit to the appropriate number, press the RIGHT/LEFT keys of the BLU300 to
advance to the next digit.
1010-0300, Rev 02
102
Blue Series Installation & Operation Manual
