Selecting the Startup Display
The Startup Display setting allows you to enable or disable the herald screen as seen below:
When enabled, this screen briefly appears whenever the OIT is powered up. Then the first screen of your project is
displayed.
4
To change the Startup Display, perform the following:
1. Access the
LOCAL SETUP MENU
per instructions given in the beginning of this chapter.
2. Press the
F4
key, or use the up/down arrow keys to move the blinking cursor to
4.HMI Setup
.
Press the
ENTER
key.
3. Use the up/down arrow keys to move the blinking cursor to
8.Start-up display
.
Press the
ENTER
key.
4. From the
START-UP DISPLAY
menu, use the up/down arrow keys to move the blinking cursor to
1.HMI
Default
or
2. User Defined.
5. Press the
ENTER
key to save the change and go back to the
HMI SETUP
menu. Press the
ESC
key to
cancel any changes.
HMI Configuration Settings
The BlueLeaf software has several configurable settings that can be set and will download to the OIT every time a project is
downloaded. Some of the settings that can be changed in the OIT Local Setup menu can be configured here.
1010-0300, Rev 02
Basic Operation of the BLU300
57
