Lenovo System x3550 M5, Installation And Service Manual

Page: 258 / 1144

Four 3.5-inch hot-swap or simple-swap hard disk drive server configuration:
Front USB assembly
Figure 164. Front USB connector assembly installation for four 3.5-inch hot-swap or simple-swap hard
disk drive server configuration
Step 3. Carefully push the media cage back into the chassis (see “Replacing the media cage” on page
237). Remember to reconnect the cables that were removed from the system board.
Step 4. Reinstall the cover (see “Replacing the cover” on page 120).
Step 5. Reconnect the power cords and any cables that you removed.
Step 6. Slide the server into the rack.
Step 7. Turn on the peripheral devices and the server.
Removing the front video connector assembly
Use this information to remove the front video connector assembly.
To remove the front video connector assembly, complete the following steps:
Step 1. Read the safety information that begins on “Safety” on page v and “Installation guidelines” on
page 116.
Step 2. Turn off the server and peripheral devices and disconnect the power cords and all external cables,
if necessary.
Step 3. Remove the cover (see “Removing the cover” on page 119).
Step 4. Remove the media cage (see “Removing the media cage” on page 234).
Step 5. Loosen the screws that secure the front video connector assembly to the media cage; then, remove
the assembly from the media cage.
Note: Refer to the illustration that applies to your particular server configuration.
244
Lenovo System x3550 M5 Installation and Service Guide