6 List Sequence Measurements
Meas Setup
Example
:LSEQ:ACQ2:SET:MPA:MBIT 1
:LSEQ:ACQ2:SET:MPA:MBIT?
:LSEQ:LIST:SET:MPA:MBIT 1,256,1032
:LSEQ:LIST:SET:MPA:MBIT?
:LSEQ:NUMB:ACQ 2
:LSEQ:ACQ1:NUMB:AST 5
:LSEQ:ACQ2:NUMB:AST 5
:LSEQ:LIST:SET:MBIT 1,2,3
:LSEQ:LIST:SET:MBIT? => 1, 2, 3, 1, 2, 3, 1, 2, 3, 1
Notes
Each bit is associated with a measurement; as shown in the bitmap table above. The value of a bit is ‘0’ if the
corresponding measurement is not selected, and ‘1’ if it is. (For example, to select EDGE EVM, set Bit 7 to ‘1’.)
The field requires a decimal entry. For example, if an analysis step requires the measurements Basic Transmit
Power and EDGE EVM, the Bit Mask for this combination is 10000001, and the value of this parameter is the
decimal number ‘129’.
Dependencies
When this parameter is set up using
"Programming Acquisitions Via SCPI" on page 376
, the value must be
entered as the decimal equivalent of the bits. For example, Bit 7 (EDGE EVM) would be entered in the form of its
decimal value (128).
Couplings
Coupled to Radio Standard, which limits the measurement choices.
The results displayed vary depending on the setting of this parameter.
Preset
1
State Saved
Saved in instrument state.
Range
0 to 65535
Min
0
Max
65535
Initial S/W
Revision
A.05.00
Help Map ID
35135
Basic Transmit Power
This parameter determines if the Basic Transmit Power measurement is computed on the selected
analysis step.
parameter_table_23.52941
52.94118
Key Path
Meas Setup, Step Setup, Meas Bit Mask
Preset
On
State Saved
Saved in instrument state.
Range
On | Off
Initial S/W Revision
A.05.00
442
Sequence Analyzer User's & Programmer's Reference
