6 List Sequence Measurements
Meas Setup
table_
23.52941
Key Path
Meas Setup, Acquisition Setup
Remote
Command
-To set channel number/ frequency individually:
[:SENSe]:LSEQuencer:ACQuire{1:512}:SETup:CNFRequency <real>
[:SENSe]:LSEQuencer:ACQuire{1:512}:SETup:CNFRequency?
-To set the channel number/ frequency as an array:
[:SENSe]:LSEQuencer:LIST:SETup:CNFRequency <real>,<real>,<real>,….
[:SENSe]:LSEQuencer:LIST:SETup:CNFRequency?
The array form of the command is used to make a different setting for each acquisition in the sequence (the
number of array values must match the number of acquisitions; otherwise a "settings conflict" error will occur).
NOTE: when the radio band is NONE, these SCPI commands are to configure
Frequency, otherwise, these commands are to configure channel number.
Example
:LSEQ:ACQ2:SET:CNFR 150
:LSEQ:ACQ2:SET:CNFR?
:LSEQ:LIST:SET:CNFR 1102,1e9,1.3e9,2300
:LSEQ:LIST:SET:CNFR?
Notes
For setting this parameter using SCPI, see
"Programming Acquisitions Via SCPI" on page 376
.
Dependencies
This parameter is disabled (grayed out) when Radio Setup is set to None
Couplings
The Channel parameter is coupled to the Radio Setup parameter, except when the Radio Setup parameter is set
to None.
When coupled, changes to either Channel or Frequency update the other parameter.
If a frequency is entered that does not match a channel in the currently selected channel plan the closest
channel value is displayed prefixed with a “<” or “>” depending on if the frequency entered is less than or greater
than the channel’s frequency value.
Range Varies
Preset
1
State Saved
Saved in instrument state.
Range
1 to 10838
Min
1
Max
10838
Initial S/W
Revision
A.05.00
Help Map ID
35107
422
Sequence Analyzer User's & Programmer's Reference
