ITT PumpSmart PS220, Configuration And Operation Manual

Page: 227 / 300

PS220 Configuration & Operation Guide
PS220 226
Functions &
Features
ALL PS220 Features are designed to operate in REMOTE mode.
Never operate rotating equipment unless all protective coupling and shaft guards are in place.
Personal injury may occur if the driven equipment is operated without coupling and shaft guards.
WARNING
Observe all CAUTIONS and WARNINGS highlighted in the ACS880 Hardware Manual, PS220
Configuration and Operation Guide and Installation, Operation and Maintenance Guide for the
applied driven equipment prior to starting.
WARNING
The steps required to switch from Remote to Local mode.
1. Press “Loc/Rem” button 1. Press Green Start 1. Wait for pump to start
2. Remote Control Start/Stop
1. H-O-A DI1, 2
This is the most common External Switch Combination used on the PS220
Refer to the diagram below.
Functionality:
Control from one external location.
DI1 is assigned to “Auto”.
DI2 is assigned to Hand, or “Speed Override”.
All switches are normally open