PS220 Configuration & Operation Guide
PS220 134
Functions &
Features
2. Configure the Control Modes Unit of Measure.
The configuration of the PumpSmart PS220’s unit selection will determine the labeling used to control the pump, the set-
point, and the actual feedback from the transmitter. Following are the available units based on your selection in 1 above.
3. Configure the Regulation Mode of the Transmitter to be used.
The configuration of transmitter location on the PumpSmart SP220 identifies whether the transmitter is on the suction
side of the piping system or on the discharge.
Note:
When choosing suction side, the software will automatically invert the actual signal. (A rising value will increase the speed
of the pump to maintain the process setpoint). Check to be sure that the transmitter being used does not do this as stan-
dard.
Refer to the “Regulation Mode” in this manual for more information.
4. Configure all of the Transmitters Detail
Configure the physical identity of the Analog Input’s transmitter, or AI#, used for the Control Mode
NOTES
1. # = The identification of the Analog Inputs physical wired connection. 1, 2 etc.
2. When Selecting the Analog Input make sure that it is connected to the correct input
3. For More detailed information on Analog Input configuration please refer to Analog Inputs I this manual.
Configure the minimum scaled value of the AI# transmitters signal.
“AI# scaled at AI# min” refers to the transmitter value that corresponds to the minimum of the signal or the 4mA scaled
value. This is defaulted to 0.
Control
Mode
Units available for selec
�
on
PSI (DEFAULT)
Pressure
FT – FEET
Smart TDH
MPa – Mega Pascals
M - Meters
BAR
Ft – Feet (DEFAULT)
Level
In – Inches
Pressure (#)
M – Meters
# = can be
converted to
level
Cm – Centimeters
GPM – Gallons per Minute (DEFAULT)
Flow
M³/hr. – Cubic meters per hour
SmartFlow
BPH – Barrels Per Hour
L/s – Liters per second
Temperature
°F – Degrees Fahrenheit (DEFAULT)
°C – Degrees Celsius
Summary of Contents for PumpSmart PS220
