ITT PumpSmart PS220, Configuration And Operation Manual

Page: 168 / 300

PS220 Configuration & Operation Guide
167 PS220
Function & F
eatures
Multipump Home Screens
The following screen shots document the detail of parameters that have been pre-configured to
display on the keypad display when running the PS220 Multipump Control Function.
M/F mode:
The information displayed will either be “D2D master” or “D2D” follower. It will display “D2D
master” as soon as it has been given the start command and is running. It will never show “D2D
Follower” if a current master is running.
PUMP ADDRESS:
This is the physical address configured of the PS220 hardware. This will never change when
pumps start and stop.
To be able to determine what pump should start next if the D2D master is running, “In Theory”
if this ID is the one that is running, and it is a D2D Master the next addressed Drive that is “Avail-
able” should run next. The switching logic can override this if the run time on the lags are not
equal (3 or more pump system)
START COMMAND:
This information will either show “Start Received” or “Start Not Received”.
None of the pumps will start unless they have received a Start command. A drive that has been
issued a start command may not be running as the Multipump logic determines when it is needed
to run.