ITT PumpSmart PS220, Configuration And Operation Manual

Page: 26 / 300

PS220 Configuration & Operation Guide
25 PS220
SmartFlow
4. Configure the BEP POWER value.
1. “ARROW RIGHT” to change
2. “ARROWS” to change value
3. “Save”
4. “ARROW DOWN”
5. Configure the SO POWER value.
1. “ARROW RIGHT” to change
2. “ARROWS” to change value
3. “Save”
4. “ARROW DOWN”
Figure 2.1: Pump Performance Curve
Note
:
1. The RATED SPEED must be less than,
and no more than 10% greater than
the speed used during “Edit motor pa-
rameters”. If it is greater, you will need
to adjust parameter 30.12 upward
(Maximum speed) to allow the tune
function to work properly.
2. All values entered MUST be at Spe-
cific Gravity (SG) 1.0 or water-like.