ITT PumpSmart PS220, Configuration And Operation Manual

Page: 24 / 300

PS220 Configuration & Operation Guide
23 PS220
SmartFlow
2.1. Configure Basic SmartFlow
1. Highlight “Basic Smartflow”
2. “Select”
The next steps to be performed are:
1. Configure the Flow Unit
2. Configure the Pump Specific Properties
3. Configure Fluid Specific Gravity
4. Execute a Smartflow Tune
5. Exit the Wizard
1. Configure the Flow Unit
The SmartFlow unit selection identifies what units SmartFlow will display in. It also will be used for
providing the necessary Pump Protection and input to other internal functions when required.
Note – The SmartFlow unit can be set independently from units that may have already been used for
the language selected at first startup.
1. “ARROW UP/DOWN” to select unit
2. “Select”
3. “Next”
2. Configure the Pump Specific Properties
1. Configure the Pump Type.
2. Configure the BEP FLOW value.
3. Configure the PUMP RATED SPEED value.
4. Configure the BEP POWER value.
5. Configure the SO POWER value.
The information required for this configuration should be able to be found on the Pump Performance
Curve. See the Diagram below (page 36) as an example of a typical Pump Performance Curve.