ITT PumpSmart PS220, Configuration And Operation Manual

Page: 211 / 300

PS220 Configuration & Operation Guide
PS220 210
Functions &
Features
1. To Configure Basic SmartFlow the following steps will be performed:
1. Configure the Flow Unit
The SmartFlow unit selection identifies what units SmartFlow will display in. It also will be used for providing the necessary
Pump Protection and input to other internal functions when required.
Note:
The SmartFlow unit can be set independently from units that may have already been used for the language selected at
first startup.
2. Configure the Pump Specific Properties
1. Configure the Pump Type
The choices are:
SS Centrifugal – Single Suction Centrifugal
DS Centrifugal – Double Suction Centrifugal
Mag Drive – Magnetically Driven Pump
Metal or Nonmetallic
Magnetically driven pumps with metallic containment shell select Mag Drive. For non-metallic shells select SS Centrifugal
as the Pump Type.
PD Pump – Positive Displacement (Gear Pump)
2. Configure the BEP FLOW value.
This is the Best Efficiency Flow value form the pump curve.
3. Configure the PUMP RATED SPEED value.
4. Configure the BEP POWER value.
This is the Best Efficiency Power value from the pump curve at the rated diameter of the impeller.
5. Configure the SO POWER value.
This is the Shutoff Power value from the pump
curve at the rated diameter of the impeller. When
running the Tune function this value can be
viewed and updated for better accuracy.
The information required for the configuration
steps above can be found on a Manufacturers
Pump Performance Curve. See the chart below as
an example of a typical Pump Performance Curve.