ITT PumpSmart PS220, Configuration And Operation Manual

Page: 157 / 300

PS220 Configuration & Operation Guide
PS220 156
Functions &
Features
The following procedure, while not spinning the motor, will energize the
motor. All safety precautions must be followed before initiating the Motor ID
run. Failure to do so could result in serious injury or death.
WARNING
2. Perform a Motor ID RUN
The PumpSmart PS220 drive uses specific motor details to create a mathematical model. This
model enables more accurate motor control and is created using the motor data you have
just entered. The PS220 will be magnetizing the motor from 20 to 60 seconds at zero speed.
This is called a Standstill ID run as the motor will not turn. It is also called a MAG ID, or ID
Run. Once all the motor data has been entered, you will
be prompted as follows:
1. Request to perform a Motor ID Run.
1. “Select Yes”
2. Run the ID.
1. Push the “Green Start Button”
2. Wait
Note – Although the motor may not appear to respond to the start command.
There may be an audible high-pitched sound coming from the motor which is
normal.
Note – If the motor is repaired or replaced in the future, a Motor Identification
run must be performed again to maintain the accuracy of the PumpSmart drive.