ITT PumpSmart PS220, Configuration And Operation Manual

Page: 15 / 300

PS220 Configuration & Operation Guide
PS220 14
Basic
Startup
1.2. Basic Drive Setup Configuration Wizard
Refer the index in this manual for a more detailed description of the Functions that will
be configured with this Wizard. When this Wizard is completed, you will be able to run
the PS220 coupled to the motor in Basic Speed control mode.
This wizard will guide you, step by step as you progress, how to configure this function
for use. To access this Wizard, from the Home Screen follow the path: Menu>PS220
Configuration>Basic Startup>Basic Drive Setup
This functionality should only be configured with the PumpSmart PS220
Configuration Wizard.
Steps to be performed will be as follows:
1. Configure a Start and Stop source.
2. Configure the Min Speed.
3. Configure the Max Speed.
4. Confirm the operating mode for Speed
5. Configure a Setpoint Source
6. Exit the Wizard
The Screen Shots that follow will show you step by step, from start to finish as you
progress, how to configure this functionality.
Starting the system in Speed control can be done after this configuration is
completed.
The PumpSmart PS220 drive uses specific motor details to create a mathematical model.
This model enables more accurate motor control and is created using the motor data
you have just entered. The PS220 will be magnetizing the motor from 20 to 60 seconds
at zero speed. This is called a Standstill ID run as the motor will not turn. It is also called
a MAG ID, or ID Run. Once all the motor data has been entered, you will be prompted
as follows:
The following procedure, while not spinning the motor, will energize
the motor. All safety precautions must be followed before initiating the
Motor ID run. Failure to do so could result in serious injury or death.
WARNING