Hakko Electronics Monitouch V Series, Reference Manual

Page: 99 / 746

Chapter 3 Switch
3-4
Switch Output
♦
Two-point Pressing
When two-point pressing is necessary on the V series equipped with analog
resistance film:
Use function switches. The above problem does not occur when two-point
pressing is made on a function switch and a switch on the screen. (
For
more information on the function switch, refer to “Chapter 1 System Setting.”)
The V6 (standard) and V7 switch resolution is of an analog type using
resistance film.
Two or more points on the screen are pressed at the same time, the center of
the pressed points is output.If the center of the pressed points happens to be a
switch, this switch may activate. Do not press two or more points on the
screen at the same time.
This doesn’t occur with the matrix type V6
series.
F1
F2
F3
F4
F5
F6
F7
SYSTEM
POWER
Switch
When two points are pressed at the same time, the switch
in the center may activate.
In the case of matrix type V6 (model: V6 M):
1-output or 2-output of the switch can be set for each screen. Select [Edit]
→
[Screen
Setting]
→
[Screen Setting] dialog. Set [1 Output] or [2 Output] for [Switch Output].
•
Switch 1-output (when [1 Output] is chosen):
The pressed switch is turned on/off. If two switches are accidentally pressed at the
same time, neither switch works.
•
Switch 2-output (when [2 Output] is chosen):
The pressed switch is turned on/off. If two switches are pressed at the same time,
both switches work as intended. If three or more switches are accidentally pressed at
the same time, none of the switches work.
*
However, when an area that is out of
the switch area is pressed on the
screen, the switch will not activate
regardless of [1 Output] or [2
Output].