Hakko Electronics Monitouch V Series, Reference Manual, Page: 168 / 746

Chapter 6 Message Display (Relay/Message)
6-5
6
Rel
a
y
Mod
e
[Relay] Dialog
This is a dialog that must be set when using relay mode. It is displayed when
you click on the [Detail] icon on the relay mode tool bar.
♦
[Main] Tab Window
[Division No.]
Set a division number not registered in another mode. Usually, the division
number currently being edited (displayed in the upper right corner of the
screen) is automatically specified.
[Memory]
Specify the command memory address used to display a registered
message on the screen. The memory addresses are allocated to messages
by bits as many as [Executing Relays] (see the following section) from the
top memory address on.
[Start Message GNo. and No]
Set the top message group number and message (line) number, registered
in the message edit area, of the message that you will display in relay mode.
Starting from this message, as many messages as specified for [Executing
Relays] are allocated sequentially in 1-bit increments to memory addresses
from [Memory].