Hakko Electronics Monitouch V Series, Reference Manual, Page: 119 / 746

Chapter 3 Switch
3-24
Example 1 [Function: Overlap = ALT]
Example 2 When the overlap is displayed, the information that the switch was
pressed is transmitted to the PLC.
Set [Output Memory] in the [Function: Overlap = ON] switch.
Select from [Momentary W], [Set] and [Alternate].
To Erase the Overlap (= Overlap)
Use the [Function: Overlap = OFF] switch. This is valid for normal, call- and
multi-overlaps. There are auxiliary setting items [Action] and [Overlap No.].
•
[Action]
Select [OFF].
•
[Overlap No.]
A maximum of three overlaps can be displayed on one screen. Set [Overlap
No.] for each [Overlap] switch so that you can determine which switch acts
for which overlap.
F1
F2
F3
F4
F5
F6
F7
SYSTEM
POWER
F1
F2
F3
F4
F5
F6
F7
SYSTEM
POWER
Animation
Change
Screen
Z Z Z
Labeller
Z
Unloader
OK
Change
Screen
Animation
Change
Screen
Z Z Z Z
OK
Change Screen
Instruc-
tions
RUN
Screen
Manual
Op.
Data
Disp. Graph
Disp.
Animation
Disp.
(1)
(2)
Change
Screen
Press the
switch.
Press the
switch again.
It is possible to bring up an overlap without using the switch function but using an
external command from the PLC. (
Refer to “Chapter 2 Overlap.”)
It is possible to erase an overlap without using the switch function but using an external
command from the PLC. (
For overlaps, refer to “Chapter 2 Overlap.”)