Hakko Electronics Monitouch V Series, Reference Manual

Page: 633 / 746

Chapter 25 Memory Card Mode
25-24
Setting in Multi-overlap Edit
After an overlap part has been placed, set entry mode on the overlap. The
following setting is required in entry mode.
•
[Keypad] icon (= entry keys)
Click the [Keypad] icon in the entry mode tool bar. Choose the desired part
and place it on the overlap.
* The same division number as in the [Entry] dialog must be used for all entry
key switches.
•
[Entry Display] icon (= entry display)
Click the [Entry Display] icon in the entry mode tool bar. The pull-down menu
is displayed. To call up the overlap for number edit, choose [Numerical
Data]. To call up the overlap for name edit, choose [Character].
* The same division number as in the [Entry] dialog must be used for all entry
display parts.
When [Numerical Data] is chosen for the entry display part, the same
number of digits as specified for [Digits] for the memory card mode part must
be used. Likewise, when [Character] is chosen, the same number of bytes
as specified for [Bytes] for the memory card mode part must be used.
•
[Entry] dialog
Set the dialog on the same editing layer and in the same division as entry
keys. Note the following points for setting.
[Division No.]
Specify the same division number as specified for entry keys and entry
display parts.
[Type]
Choose [Memory Card]. The entry mode for memory card mode is set
up.
Card No. 120
CR
[Detail]
[Keypad] [Entry Display]
All of the above settings must be made. If any setting is omitted, the entry
mode does not work correctly. Take a note of this.