Hakko Electronics Monitouch V Series, Reference Manual

Page: 347 / 746

Chapter 10 Sampling
10-52
Switches for Bit Sampling
When displaying sampled data, scrolling, resetting, etc. can be performed by
setting a switch.
♦
Notes on Setting
[Division No.]
Set the same division number as that in the [Bit Sampling] dialog.
[Function]
Set the switch function. The following switch functions are available with bit
sampling.
Function Contents
Roll Up Scrolls by one data element toward the most recent entry. If all data
cannot be held in the graph, one data element at a time scrolls into
view.
Roll Down Scrolls by one data element toward the most recent entry. If all data
cannot be held in the graph, one data element at a time scrolls into
view.
Plus Block Scrolls by one page toward the most recent entry.
Minus Block Scrolls by one page toward the most recent entry.
Graph Return Returns to the most recent graph display when it is pressed while
flashing. Flashing is canceled as well as the selection.
Display
Change Changes over the status display for ON, OFF, or ON/OFF.
Sample Print Outputs all data stored in the specified buffer to the printer.
Reset When the switch is pressed once, it is turned on. Pressing it again
within 2 seconds clears the buffering area. Sampling restarts
immediately after clearing. If not pressed again within 2 seconds, the
switch is turned off, and resetting is nullified.
Display Order
Change Changes over data display order: in order of occurrence (from old to
new) or in the reverse order (from new to old).