Hakko Electronics Monitouch V Series, Reference Manual

Page: 209 / 746

Chapter 7 Entry Mode
7-18
•
Decimal point (n + 1 bits 8 to 11)
Specify the decimal point position. Up to 10 digits can be displayed in DEC
(
refer to “Chapter 5 Data Display”). Therefore “0 to 9” can be specified.
[Info. Output Memory]
The V series writes the entry mode status.
•
Entry format, write format (bits 0 to 2 and 4)
Data specified in the command memory address is written.
•
Input (bit 14)
Input status is written. Bit 14 of the entry mode for the area (base screen or
overlap 0 to 2) being placed at the top is set (1). For the remaining areas, bit
14 is reset (0).
0:
Input is not possible.
1: Input is possible.
15 14 13 12 11 10 09 08 07 06 05 04 03 02 01 00
0 0 0 0 0 0 0 0 0 0
Info. output
memory n
MSB
Write format
0: DEC
1: BCD
Input
0: Disabled
1: Enabled
LSB
Entry format
0: DEC (w/o sign)
1: DEC (w/
−
sign)
2: DEC (w/ +
−
sign)
3: HEX
4: OCT
5: BIN
6: TEXT
15 14 13 12 11 10 09 08 07 06 05 04 03 02 01 00
0 0 0 0
n + 1
Digits for entry
BCD:
1 to 8
DEC: 1 to 10
HEX: 1 to 8
OCT: 1 to 11
BIN: 1 to 32
TEXT: 1 to 80
Decimal point
BCD: 0 to 7
DEC: 0 to 9
1: Writing completed
Entered data
15 14 13 12 11 10 09 08 07 06 05 04 03 02 01 00
n + 2
15 14 13 12 11 10 09 08 07 06 05 04 03 02 01 00
n + m
The number of characters here is based on one-byte codes. Two one-byte characters
occupy one word. Therefore, the number of words occupied can be calculated by
dividing the number of characters by 2. If there is a remainder, it occupies one word.
Ex.: 3 characters = 2 words