Hakko Electronics Monitouch V Series, Reference Manual

Page: 560 / 746

Chapter 23 CF Card (V7 Only)
23-15
23
Aut
o
Upl
o
a
d
in
g of
Sc
reen
Data
Operation on the V7 Series
After storing data on the CF card, import the data into the V7 series following the
steps below.
1. Turn off the V7 series.
2. Set the DIPSW1 switch on the V7 series to ON.
3. Insert the CF card into the V7 series.
4. Turn on the V7 series. The message “Loading from CF Card.” is displayed
on the V7 series for a while. Then the screen data stored on the CF card is
written to the V7 series.
♦
Notes on Writing
•
When using the screen data file for auto-uploading, you can store only one
data file per CF card.
•
If you remove a CF card after auto-uploading and reset the power, the
message “Insert CF Card in V7.” is displayed. You cannot start the V7 series
correctly. Insert the CF card or set the DIPSW1 dipswitch to OFF. Then
reset the power.
•
Once auto-uploading has been performed, all screen data that was written to
the V7 series (including I/F drivers, fonts, etc.,) is changed into screen data
for auto-uploading. Note that the data that was written to the V7 series is
overwritten and lost even if you remove the CF card and reset the DIPSW1
switch to OFF.