Hakko Electronics Monitouch V Series, Reference Manual

Page: 681 / 746

Chapter 29 Language Selection
29-14
Macro Command [CHG_LANG]
•
When immediately after the RUN mode is started, the language you set for
[Initial Displayed Language] of the [Font Setting] dialog is displayed.
•
When you change the language in the RUN mode, you can perform
[CHG_LANG] in the [SYS] macro command. However, the timing of the
language change is the same as the timing of the screen change.
[CHG_LANG]
Available Devices
CHG_LANG: Language change SYS(CHG_LANG) F1
Internal
memory
PLC memory Constant Memory Card Indirect W word
F0
Command
name
F1
F1 Language number (0 - 7)
Although the setting range for [Changing Characters] in the [Font Setting]
dialog and [Language] in the [Display Environment] dialog is [1] to [8], the
range of [CHG_LANG] is [0] to [7].
Ex.:
Set the displayed language using the ON macro of the screen change switch.
If you press the “Japanese” switch, the screen changes to the next screen, which
displays in Japanese. If you press the “Korean” switch, the screen changes to the next
screen, which displays in Korean.
Which language do you prefer?
Japanese Korean
Switch “Japanese”
• Function Screen No.1
• Use the ON macro
On macro edit
$u00100 = 0 (W)
SYS (CHG_LANG) $u00100
Switch “Korean”
• Function Screen No.1
• Use the ON macro
On macro edit
$u00100 = 1 (W)
SYS (CHG_LANG) $u00100
Screen No. 0
Screen No. 1