Hakko Electronics Monitouch V Series, Reference Manual, Page: 626 / 746

Chapter 25 Memory Card Mode
25-17
25
M
e
m
o
ry
C
a
rd
M
o
d
e
•
B. n + 1 (RCV_FILENo)
This bit is used to specify a file number from the PLC when bit 9 (file lock) or
bit 8 (record lock) of “RCV_FLAG” (n) is set to “1.” File numbers can be
specified from the PLC, not on the screen.
* When [Not Used] or [Buffering File] is chosen for [Type] of the specified file
number, the file number cannot be selected.
•
C. n + 2 (RCV_RECDNo)
This bit is used to specify a record number from the PLC when bit 8 (record
lock) of “RCV_FLAG” (n) is set to “1.” Record numbers can be specified from
the PLC, not on the screen. Unlike a selection by the [Record Select] switch,
the record number specified is displayed on top of the display area.
[Key Display Location]
OVLP0 (= overlap 0)/OVLP1/OVLP2/BASE
When editing memory card number and name, file name, and record name,
choose where to place the entry keys from overlaps 0 to 2 or the base
screen. Only one place (base, overlap 0 to 2) can be chosen for the entry
keys.
[Process Cycle]
Set a cycle for the V series to read the PLC data while it is communicating
with the PLC. For more information, refer to “Appendix 2 Process Cycle.”
♦
[Char. Prop.] Tab Window
Set properties of characters for displaying file or record numbers or names in the
display area. For more information, refer to “Chapter 6 Message Display
(Relay/Message)” (page 6-7).
10 File selection
In the display area part:
[0]: Only the files for [Type: Data File] are displayed.
[1]: All files are displayed.
11 Not used This bit must be reset to “0.”
12 Quick selection
When bit 14 or bit 15 is set to “1,” while this bit is set, data is
transferred upon selection of a record in the V series.
13 Not used This bit must be reset to “0.”
14
Transfer from V series
→
PLC
Data is transferred from the V series (memory card) to PLC at the
edge of [0
→
1]. When transferring has been completed, bit 14 of
“CFM_TRFIN” (I/F memory n + 5) is set to “1.” After transfer, reset
this bit to “0.”
15
Transfer from PLC
→
V
series
Data is transferred from PLC to the V series (memory card) at the
edge of [0
→
1]. When transferring has been completed, bit 15 of
“CFM_TRFIN” (I/F memory n + 5) is set to “1.” After transfer, reset
this bit to “0.”
Bit No. Contents Description