Hakko Electronics Monitouch V Series, Reference Manual

Page: 417 / 746

Chapter 13 Macro
13-34
Event Timer Macro
The “event timer macro” is executed at regular intervals regardless of the screen
displayed.
Setting Items
•
[System Setting]
→
[Macro Setting]
→
[Event Timer Macro]
•
[Item]
→
[Macro Block Edit] ( Refer to Chapter 4 in the Reference
Manual (Operation).)
Macro Setting
♦
[Event Timer Macro] Tab Window
[Event Timer No.] ( 0 to 7)
A maximum of eight event timer macro
commands can be set. Check the box
when setting.
[Cycle Time (Sec)] (0 to 3600)
The macro command is executed each
time the specified time has elapsed from
the start of communications.
[Macro No.]
Set the macro block number to be
executed.
Notes
1. When multiple timers for event timer macro commands are up at the same
time:
The smaller number of [Event Timer No.] has priority in execution. The next
event timer macro command is executed after the previous event timer
macro command has been completed.
2. When accessing the same PLC memory address in some event timer macro
commands:
The processing ability of macro commands will be improved if you set event
timer macro No. 0 that reads from the internal memory address and make
other event timer macro commands refer to this internal memory address.
Basically, to improve the processing ability of macro commands, reduce the
number of times that access to a PLC memory address is repeated.
For information on the screen process cycle, refer to “Appendix 2 Process Cycle.”
Event timer macro No. 0
Event timer macro No. 1
CYCLE macro