Hakko Electronics Monitouch V Series, Reference Manual, Page: 724 / 746

Appendix 3 Error
A3-3
A3
E
rro
rs
D
isp
la
y
e
d
o
n
th
e
V
7
Se
ri
e
s
Error Messages for Network Communication
•
Ethernet
•
MELSECNET/10
•
CC-LINK
Error Message Contents Solution
Ethernet Error: XXXX The Ethernet status is saved at system
memory address $s518 and a code
other than “0” (normal) is received.
XXXX : Error No. For the contents and solution to each error
number, refer to Chapter 4 of the Hardware
Specifications Manual.
Error Message Contents Solution
I/F Board Err The I/F unit for NET/10 has an error.
Contact your local distributor.
Request Code Err The request command from NET/10
has an error.
Request Data Err The request data from NET/10 has an
error.
Word Writing to Sp.
Relay
(Mitsubishi A series) Word writing to a special relay (M9000
and later) is attempted. (Note: Only bit
writing is possible for special relays
when connecting with NET/10.) Do not attempt to perform word writing to
special relays.
Error Message Contents Solution
I/F Board Err The I/F unit for CC-LINK has an error. Contact your local distributor.
No. of Occupy
Setting Err The number of occupy in [Comm.
Parameter] is different from the number
of occupy by switches. Check the setting of the number of occupy.
Network I/O Access
Err MONITOUCH is about to access
exceeding the set number of
input/output words. Check the memory for the network I/O in the
screen data file.
Station Number Err The port number set by a switch is not
within the setting range (1 to 64). Specify the port number within the setting
range.
Word Writing to Sp.
Relay Word writing to a special relay (M9000
and later) is attempted.
* Only bit writing is possible for special
relays when connecting with
CC-LINK.
Do not attempt to perform word writing to
special relays.