Hakko Electronics Monitouch V Series, Reference Manual, Page: 289 / 746

Chapter 9 Graphic Display
9-14
[Parameter]
Parameters are required when moving or transforming graphics. Specify the
total number of parameters provided to the graphics you are going to use in
graphic mode. From this total and parameter numbers, memory allocation is
determined.
Example:
[Memory: D200]
[Type: 1-Graphic]
[Start Graphic: GNo. 1 No. 4]
[Number of Relays: 20]
[Parameter: 4]
From the above settings, memory is allocated as shown below:
[Process Cycle]
Refer to “Appendix 2 Process Cycle.”
15 14 13 12 11 10 09 08 07 06 05 04 03 02 01 00
19 1 17 16 15 14 13 12 11 10 9 8 7 6 5 4
MSB LSB
Bit No. of D200
Graphic No. 1
graphic No.
(Bit ON)
16 bits (relays)
[Number of Relays: 20]
It is possible to assign 20 graphics to 16 bits in
D200 and 4 bits in D201.
D200 For graphic relay motion (16 relays)
D201 For graphic relay motion (4 relays)
D202 For parameter No. 1
D203 For parameter No. 2
D204 For parameter No. 3
D205 For parameter No. 4
15 14 13 12 11 10 09 08 07 06 05 04 03 02 01 00
23 22 21 20
Bit No. of D201
Graphic No. 1
graphic No.
(Bit ON)
4 bits (relays)
Total: 20 = number of relays