Hakko Electronics Monitouch V Series, Reference Manual, Page: 202 / 746

Chapter 7 Entry Mode
7-11
7
En
try
D
ial
og
Se
ttin
g
- Entry target selection (bit 12)
The entry target is chosen.
0:
Data display part
1: Table data display part
- Writing enabled/disabled (bit 15)
This bit is available when [ Use Writing Enabled Bit] is checked.
This bit determines whether or not the keypad is enabled.
0:
Keypad is disabled. When pressed, an error buzzer sounds.
1: Keypad works normally.
- Line selection/Column selection (n + 1)
These bits become active when bit 12 of command memory “n” is set (1).
Cursor is displayed on the designated line Nos. 1 to 20 and column Nos.
1 to 25.
[Info. Output Memory]
The V series writes the entry mode status. The contents to be written
depend on the setting of [
Lines/Columns Output] in the [Detail] tab
window of the [Entry] dialog.
•
When [ Lines/Columns Output] is unchecked
15 14 13 12 11 10 09 08 07 06 05 04 03 02 01 00
0 0
Command
memory n
MSB
Bit No. Type
11 10 Data display Block
0 0 Base Data block area No. 0
0 1 Overlap 0 Data block area No. 1
1 0 Overlap 1 Data block area No. 2
1 1 Overlap 2 Data block area No. 3
Data display number (selection order: 0 to 255)
Input
0: Disabled
1: Enabled
Writing completed/not completed
0: Writing not completed
1: Writing completed
Entry area selection (0 to 3)
LSB
Entered data
15 14 13 12 11 10 09 08 07 06 05 04 03 02 01 00
0 0 0
n + 1
Block No. (0 to 1023)
15 14 13 12 11 10 09 08 07 06 05 04 03 02 01 00
n + 2
15 14 13 12 11 10 09 08 07 06 05 04 03 02 01 00
n + m