Hakko Electronics Monitouch V Series, Reference Manual

Page: 104 / 746

Chapter 3 Switch
3-9
3
[Swi
tc
h] Di
al
og
•
For bit-writable memory:
The operation result will be directly written on the bits of [Output Memory] as
shown below, regardless of whether [Momentary] or [Momentary W] is
chosen.
Example: When [M10] is specified for [Output Memory]:
•
For non-bit-writable memory:
Switch activation is processed in the unit of bits within V series, therefore, if
the non-bit-writable memory is specified for [Output Memory], different
processing methods are employed for the [Momentary]/[Momentary W]
selection. Processing when [Momentary] is chosen:
1. One word of [Output Memory] is read.
2. The result of [Output Action] is written into one word of [Output Memory].
(Other bits are kept intact.)
Example: When [D100-10] is specified for [Output Memory]:
Processing when [Momentary W] is chosen:
The result is directly written into one word of [Output Memory]. (Other bits
are cleared.) Therefore, be sure to secure a one-word area.
Example: When [D100-10] is specified for [Output Memory]:
Refer to the regarding whether the memory is bit-writable or not.
. . .
. . .
. . .
. . . . . .
. . .
. . .
. . . . . .
. . .
. . .
. . . . . .
. . .
. . .
. . .
RUN
STOP
F1
F2
F3
F4
F5
F6
F7
SYSTEM
POWER
Write the ON state of M10.
F1
F2
F3
F4
F5
F6
F7
SYSTEM
POWER
0 0 0 0 0 0 0 0 0 0 0 0 0 1 1 1
0 0 0 0 0 1 0 0 0 0 0 0 0 1 1 1
. . .
. . .
. . .
. . . . . .
. . .
. . .
. . . . . .
. . .
. . .
. . . . . .
. . .
. . .
. . . RUN
STOP
1. Reads data in D100
2. Writes data while setting D100-10 to ON.
0 0 0 0 0 1 0 0 0 0 0 0 0 0 0 0
. . .
. . .
. . .
. . . . . .
. . .
. . .
. . . . . .
. . .
. . .
. . . . . .
. . .
. . .
. . .
RUN
STOP
F1
F2
F3
F4
F5
F6
F7
SYSTEM
POWER
Writes one-word data while
setting D100-10 to ON.
In the case of matrix type V6 (model: V6 M):
Select [Screen Setting]
→
[Switch Output], and select [2-output]. When the output
memory is set within the same word for switches of [Momentary W], the two-point output
may not be available. Use [Momentary] in such a case. (For switch output, refer to
page 3-4.)