Fagor CNC 8060, Installation Manual

Page: 294 / 698

Installation manual.
CNC 8060
CNC 8065
2.
MACHINE PA
RAMETERS.
Machine parameters
for kinetics.
·294·
(R
EF
: 1709)
TDATA51
Rotate the part coordinate system when rotating the table.
Possible values: 0 (yes) / 1 (no).
Default value: 0.
Having the RTCP mode active, this parameter determines whether the part coordinate
system is fixed on the part and rotates with it or it stays parallel to the machine coordinate
system.
TDATA52
Apply full RTCP.
Possible values: 0 (yes) / 1 (no).
Default value: 0.
This parameter determines whether the CNC applies the RTCP to the whole kinematics or
only to the spindle side.
TDATA51 Meaning.
0 When changing the part orientation, the position occupied by the tool tip on the
part does not change. The coordinate system is fixed on the part and rotates with
it.
1 When changing the part orientation, the position occupied by the point set as part
zero does not change. The coordinate system stays parallel to the machine
coordinate system.
TDATA52 Meaning.
0 Full RTCP, table + spindle.
1 RTCP considering only the spindle side.
X'
Z'
#RTCP ON
B-30
B
TDATA51 = 0
X'
Z'
TDATA51 = 1
X'
Z'