Fagor CNC 8060, Installation Manual

Page: 489 / 698

Installation manual.
CNC 8060
CNC 8065
TOOL
A
ND MA
GAZIN
E
MANAGEMEN
T.
7.
Syn
c
h
ronou
s mag
a
zine
wi
th
cha
nge
r arm
and
1
cla
w
·489·
(R
EF
: 1709)
TMOPERATION = 13
Orienting two magazines.
This operation is an optimization of the tool change that permits orienting two magazines
while machining. Activate the MZROT mark in both magazines to indicate that the operation
has been completed, whether the magazines have been oriented or not.
TMOPERATION = 14
Leave the spindle tool in the magazine and take a tool from another magazine.
The sequence of this operation is the following.
1 Take the tool from the spindle with holder 1 and activate the mark SPDLTOCH1.
2 Leave the tool of holder 1 in the magazine and activate the mark CH1TOMZ.
3 Take the tool from the other magazine with holder ·1· and activate the mark MZTOCH1.
4 Insert the tool of holder 1 in the spindle and activate CH1TOSPDL.
NEXTPOS=# Magazine position to leave the tool.
TAKEPOS=# Magazine position to pick up the tool.
MZID The lower portion of this register indicates the destination magazine
for the tool and the higher portion the source magazine for the tool.
TAKEPOS=# Magazine position to pick up the tool.
LEAVEPOS=# Magazine position to leave the tool.
MZID The lower portion of this register indicates the destination magazine
for the tool and the higher portion the source magazine for the tool.