Fagor CNC 8060, Installation Manual

Page: 95 / 698

Installation manual.
CNC 8060
CNC 8065
MACHINE PA
RAMETERS.
2.
Gen
e
ral machin
e parameters.
·95·
(R
EF
: 1709)
2.3.19 Numbering of the digital outputs (CANfagor bus).
NDOMOD
Total number of digital output modules.
Possible values: From 0 to 64.
Default value: 0 (no numbering is defined).
Associated variable: (V.)MPG.NDOMOD
This parameter shows the number of digital outputs modules connected to the same bus
CAN. After defining this parameter, it is possible to set the numbering of the digital outputs
of each module by assigning a base index to the first of them. If this parameter is not set,
the CNC numbers the digital outputs sequentially according to the order of the modules in
the bus.
DOMODADDR
Table of digital output modules.
This parameter shows the list of digital output modules connected to the same bus CAN.
When inserting a new module, the CNC will assign the numbering of the table to the first
modules and the next valid base index after the highest one assigned until then to the last
module.
DOMOD n
Base index of the digital output modules.
Possible values: From 0 to 1009.
Default value: The first valid value.
Associated variable: (V.)MPG.DOMODADDR[nb]
Parameter included in the DOMODADDR table.
This parameter sets the base index from which the digital outputs of the module are
numbered. The values of the base index must be comply with the formula "16n + 1" (i.e. 1,
17, 33, etc.). If an invalid base index is entered, it assumes the nearest previous valid one.
The base indexes may follow any order, they do not have to be sequential.