Fagor CNC 8060, Installation Manual, Page: 457 / 698

Installation manual.
CNC 8060
CNC 8065
TOOL
A
ND MA
GAZIN
E
MANAGEMEN
T.
7.
Communica
tio
n
betwee
n
ma
nage
r
a
nd PLC.
·457·
(R
EF
: 1709)
CH2TOMZ Use it with an asynchronous magazine or synchronous with arm.
The PLC must set this mark high (=1) after taking the tool from the
tool changer arm 2 to the magazine.
SPDLTOGR Use it with a magazine that admits ground tools. The PLC must set
this mark high (=1) after taking the tool from the spindle to ground.
GRTOSPDL Use it with a magazine that admits ground tools. The PLC must set
this mark high (=1) after taking the tool from the ground to the spindle.
MZTOSPDL Use it with a synchronous magazine (without arm). The PLC must
set this mark high (=1) after taking the tool from the magazine to the
spindle.
SPDLTOMZ Use it with a synchronous magazine (without arm). The PLC must
set this mark high (=1) after taking the tool from the spindle to the
magazine.
MZROT Use it with a turret-type magazine and with a synchronous
magazine.
The PLC must set this mark high (=1) when the turret has rotated.
In the synchronous magazine, it is used to optimize the change by
orienting the magazine while machining. The PLC must set this mark
to (=1) to indicate that the operation has been completed, whether
it has been oriented or not.
TCHANGEOK On asynchronous magazines (with changer arm of independent
movements) the following mark may be activated so the CNC goes
on executing the program while the tool is being taken to the
magazine.
The PLC must set this mark high (=1) to "tell" the manager to go on
executing the program while the tool is being taken to the magazine.
MZPOS On random magazines, magazine orientations may be optimized if
the manager knows the position selected at all times. The PLC must
indicate in this register the current position of the magazine; when
not using this register, the PLC must set it to ·0·.
On turret magazines, it is possible to select a position (#ROTATEMZ
instruction). The PLC must indicate in this register the current
position of the magazine; if the register has a value of ·0·, the PLC
will issue the corresponding error.
Marks / Registers. Meaning,