Fagor CNC 8060, Installation Manual

Page: 108 / 698

Installation manual.
CNC 8060
CNC 8065
2.
MACHINE PA
RAMETERS.
Gen
e
ral machin
e parameters.
·108·
(R
EF
: 1709)
For example, if the parameter is with a value of ·107·, it indicates that the CNC uses analog
input ·1· of the drive whose logic address is ·7·
GAPDISTLIMIT
Distance corresponding to the limit analog signal of the sensor.
Possible values: From 0 to 99999.9999 mm / From 0 to 3937.00787 inches.
Default value: 10.0000 mm / 0.39370 inch.
Associated variable: (V.)MPG.GAPDISTLIMIT
Distance corresponding to the limit analog signal of the sensor (parameter GAPVOLTLIMIT).
GAPVOLTLIMIT
Voltage corresponding to the travel limit of the sensor.
Possible values: From 0 to 10000 mV
Default value: 10000 mV.
Associated variable: (V.)MPG.GAPVOLTLIMIT
Voltage (in millivolts) corresponding to the limit path of the sensor (parameter
GAPDISTLIMIT).
GAPSENSOROFFSET
Offset to apply to the sensor.
Possible values: Between ±10000 mV.
Default value: 0 mV.
Associated variable: (V.)MPG.GAPSENSOROFFSET
Offset (in millivolts) to apply to the sensor from the CNC. If a Fagor analog input is used, this
parameter is not required, as each has its own offset.
GAPSENSORCH
Change the sensor signal sign.
Possible values: Yes / No.
Default value: No.
Associated variable: (V.)MPG.GAPSENSORCH
Change the sensor signal sign.
GAPGAIN
Proportional gain when applying in GAPCTRL.
Possible values: From 0.0000 to 100.0000.
Default value: 0.2.
Associated variable: (V.)MPG.GAPGAIN
Proportional gain applied to the signal sensor, in position. To use values greater than 0.2
(close to 1), it is advisable to use the parameter GAPSENSORFILTER.