Fagor CNC 8060, Installation Manual

Page: 31 / 698

Installation manual.
CNC 8060
CNC 8065
·31·
(R
EF
: 1709)
Ref. 1603
Ref. 1604
Ref. 1709
Apply tool radius compensation in G00. • Machine parameter: G00COMP.
The default value of parameter CANMODE is now CANopen. • Machine parameter: CANMODE.
PLC. Asynchronous magazine. The TMOPERATION mark can take the value
of 16. • PLC mark: TMOPERATION.
Software V05.45
Safe probing cycles. • PLC mark: PROBE1MONIT,
PROBE2MONIT.
Probe enabled. • PLC mark: PROBE1ENA,
PROBE2ENA.
Software V05.50
Number the digital inputs of the CANopen bus based on logic blocks. • Machine parameters: NDIMOD
DIMODADDR
NODE
BLOCK
ADDRESS
NDI
Number the digital outputs of the CANopen bus based on logic blocks. • Machine parameters: NDOMOD
DOMODADDR
NODE
BLOCK
ADDRESS
NDO
Enable/disable a PT100 input from the PLC. • PLC mark. PT100OFF1..PT100OFF20
New management of M06 in turret-type magazines • Function: T and M06.
Software V05.60
The “CNC Variables” Chapter has been removed from the manual. New
manual. •
Operating Terms. • Variables: G.CNCDISSTAT
Basic volumetric compensation. • Machine parameters:
VMOVAXIS1, VMOVAXIS2, VMOVAXIS3
NPOINTS1, NPOINTS2, NPOINTS3
INIPOSAX1, INIPOSAX2, INIPOSAX3
INCREAX1, INCREAX2, INCREAX3
HMI. Define the initial position of the interface on the screen. The interface can
be moved by clicking with the mouse on the icon showing the program status
of the active channel. • Machine parameters: POSX
POSY
HMI. Define the size of the interface. • Machine parameters: RESOLUTION
WIDTH
HEIGHT
HMI. Customize the number of softkeys and their size. • Machine parameters: HMENUNSOFTKEY
HMENUNSOFTKEY
SOFTKEYMETRICS
Non-modal G02 and G03 functions. • Machine parameters: G2G3MODAL
Non-modal function G00. • Machine parameters: G0MODAL
IMOVE
Subroutine associated with the reset. • Subroutine: PROGRAM_RESET
Subroutine associated with the tool calibration cycle. • Subroutine: KinCal_Begin.nc
KinCal_End.nc
Status of the power-up and power-down process. • Variables: (V.)E.CNCLOGST
Logic number of the axis, according to its order in the channel. • Variables: (V.)[ch].G.NLOGAXIS1
(V.)[ch].G.NLOGAXIS2
··
(V.)[ch].G.NLOGAXISn
• Variables: (V.)[ch].G.NLOGSPDL1
(V.)[ch].G.NLOGSPDL2
··
(V.)[ch].G.NLOGSPDLn
Modify the proportional gain (Kp) of the tandem from the PLC. • Variables: V.MPG.TPROGAIN[nb]
Disable the feedback input alarms for the RCS-S module. • Machine parameters: DRIVEVAR.
Disable the local feedback input alarms. • PLC marks: LCOUNTALARMOFF1
LCOUNTALARMOFF2
FeeDat / EnDAt encoder Information. • Machine parameters: NAME
TYPE
RESOLUTION
SERIALNUMBER
DATALENGTH
EnDat transmission format. • Machine parameters: ENDAT
ENDATCLKFREQ
Software V05.40