Fagor CNC 8060, Installation Manual

Page: 596 / 698

Installation manual.
CNC 8060
CNC 8065
12.
VOLUMETRIC COMPENSATION.
Erro
r messag
e
s
(cau
se and sol
u
ti
on).
·596·
(R
EF
: 1709)
12.3 Error messages (cause and solution).
0046 'Nonexistent axis'
DETECTION During the validation of the machine parameters.
CAUSE The possible causes are:
• The user has assigned the name of an axis that does not exist to
a machine parameter.
• Either the VMOVAXIS or VCOMPAXIS axis is undefined in the
basic volumetric compensation.
SOLUTION Correct the machine parameters. The valid axis names are the ones
defined in parameter AXISNAME.
1445 'Wrong parameter value'
DETECTION During execution.
CAUSE A parameter has an invalid value in an instruction or a fixed cycle.
SOLUTION Check the program.
1447 'Software option not allowed'
DETECTION During execution.
CAUSE The CNC does not have the software option required to execute the
programmed command.
SOLUTION In diagnosis mode, it is possible to check the software options offered
by the CNC.
9347 'Axis repeated in VOLCOMP'
DETECTION On CNC power-up or when validating the machine parameters.
CAUSE The same axis is defined twice in the VMOVAXIS or VCOMPAXIS
volumetric compensation parameters.
SOLUTION Correct the machine parameters.
23101 'Error when analyzing the volumetric compensation definition file'
DETECTION On CNC power-up or when validating the machine parameters.
CAUSE The volumetric definition file does not contain the proper data.
Basic volumetric compensation:
• The file is not in csv format.
• The format of the file defined in VCOMPFILE is incorrect.
• The file defined in VCOMPFILE does not have all the points
defined. The number of points is defined by the expression:
NPOINTSAX1 × NPOINTSAX2 × NPOINTSAX3
Medium and large volumetric compensation:
• The format of the file defined in VCOMPFILE is incorrect.
SOLUTION Select a proper file. The file must be in csv format and have all the
points defined in the basic volumetric compensation.
23102 'Volumetric compensation system error; Compensation off'
DETECTION During execution.
CAUSE The CNC has detected an internal error when calculating the
volumetric compensation and has canceled the compensation values.
SOLUTION Contact Fagor Automation.
23103 'The VOLCOMP mark cannot be activated if a table is not validated'
DETECTION During execution.
CAUSE The PLC has tried to activate a volumetric compensation that is not
defined properly and therefore the machine cannot be compensated.
SOLUTION Define a proper volumetric compensation in the machine parameters
(VOLCOMP parameters).