Fagor CNC 8060, Installation Manual, Page: 634 / 698

Installation manual.
CNC 8060
CNC 8065
14.
SUBROUTINES.
Subro
u
tine associ
ate
d
with th
e
co
mma
nd #PIERCIN
G
.
·634·
(R
EF
: 1709)
14.15 Subroutine associated with the command #PIERCING.
The command #PIERCING executes the associated subroutine after updating the piercing
variables ((V.) TTPIR.name). This command is specifically for laser machines, where this
subroutine must perform the initial piercing operations.
Management of the PIERCING mark in the subroutine.
The OEM must manage the PIERCING mark from this subroutine. At the start of the
subroutine (or when the OEM deems it necessary), the OEM must activate the PIERCING
mark (assigning it the value 1) to indicate to the PLC that it must start the piercing operation.
At the end of the subroutine (or when the OEM deems it necessary), the OEM must
deactivate this mark (assigning it the value 0) to indicate to the CNC that it has finished the
piercing operation.
• The instruction #PLC makes it possible to manage a PLC mark from the part or subroutine
program, without interrupting the block preparation.
• This mark shows the state of the variable V.PLC.PIERCING. The OEM can also use this
variable in the subroutine associated with the piercing (by default, Piercing.fst) to modify
the status of this mark. Entering this variable interrupts the block preparation.
14.15.1 Configure the subroutines.
Assign the subroutine to the command.
Name and location of the subroutine.
This subroutine must be defined in the general parameter PIERCING (by default,
Piercing.fst) and saved in the folder ..\Mtb\Sub. If there are several channels, there may be
a different subroutine for each channel.
Since it is an OEM subroutine with an .fst extension, the CNC loads this subroutine into the
RAM of the CNC. See
"14.1 Run subroutines from RAM (extension *.fst)." on page 617.
Subroutine specifically for the laser model. The subroutines supplied by Fagor provide basic laser
management, so they should be configured appropriately by the OEM. The OEM is responsible for
ensuring that the subroutine complies with all safety aspects relating to handling the laser.
If this version is updated, the CNC behaves as follows.
• For the two first two installation options, the CNC will only copy the subroutines in the folder
..\Mtb\Sub if they do not already exist.
• In the third installation option, "rename previous version and install it completely", the CNC always
updates the subroutines.
Parameter. Meaning.
PIERCING CHN Subroutine associated with the command #PIERCING.
[CHN] ....... General machine parameter of the channel.