Administration Manual ip500pbxw – English
139
B
Cordless Phone Detailed Instructions
Battery requirements:
The handset requires power source of two rechargeable NiMH batteries, size AAA 1.2V 750mAh
(HR10/44).
•
Do not allow the handset to come into contact with liquids or moisture.
•
Do not allow the charging contacts or the battery to come into contact with conductive materials.
•
There is a slight chance that the telephone could be damaged by an electrical storm. It is recommended that
users unplug the phone from the mains supply and telephone socket during a storm.
•
Do not use the handset in an explosive hazard area such as where there is gas leaking.
•
Because the phone works by sending radio signals between the base unit and the handset, wearers of
hearing aids may experience interference in the form of a humming noise.
•
We advise that this phone should not be used near intensive care medical equipment or by persons with
pacemakers.
•
Your phone can interfere with electrical equipment such as answering machines, TV and radio sets, clock
radios and computers if placed too close. It is recommended that you position the ip500pbxw at least one
meter from such appliance
WARNING
Use only the mains adapter supplied with this telephone. Incorrect adapter polarity or
voltage can seriously damage the telephone. Input: 220 VAC 50 Hz Output: 9 VDC 300 mA
WARNING
THERE IS A RISK OF EXPLOSION IF THE BATTERY IS REPLACED BY AN
INCORRECT TYPE. Never use nonrechargeable batteries. Use two rechargeable NiMH
batteries, size AAA 1.2V 750mAh (HR10/44) only. NiMH batteries must be disposed of in
accordance with the applicable waste disposal regulations.
Setting up your phone
Connect the output plug of the mains adapter to the socket on the back of the charger unit and the mains adapter to the
wall mains supply.
Place the 2 rechargeable NiMH AAA batteries (included), observing their polarities, into the battery compartment on the
handset. Slide the battery door firmly into place.
Place the handset on the base unit and let the batteries charge for a full 14 hours before using it for the first time.
Note
The handset may get warm during the initial charge. This is normal
Switch on/off your phone
To switch off the power of your phone press and hold
L
during standby.
To switch on the power of your phone press
L
.
The battery icon will display in 10 seconds. If the battery level is too low,
the handset may not power up.
To set your handset’s clock
Your clock resets to 12:00AM or 00:00, depending on time format you are using, each time you replace the batteries
or switch off the phone.
To set your clock:
Press MENU during standby.
Press
}
/
{
to select
DISPLAY
, and then press
OK
.
Press
}
/
{
to select
CLOCK
, and then press
OK
.
Press
8
/
9
to change the
HOUR
, and then press
}
Press
8
/
9
to change the
MINUTE
.
If you set the time format of your clock to 12 hours, go to step 6. If you set it to 24 hours, go to step 7.
