5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
865
Parameters
None
Default
The default is Enabled.
Command Mode
Router OSPFv3 Config
8-83
exit-overflow-interval (OSPFV3)
Configures the exit overflow interval for the OSPF. Specifically, it indicates the number of seconds that a
router will wait after entering the overflow state before attempting to exit the overflow state. This lets the
router to originate non-defaultAS-external-LSAs again. When the value is set to 0, the router will not leave
the overflow state until restarted.
The
no
command configures the default exit overflow interval for the OSPF.
exit-overflow-interval 0-2147483647
no exit-overflow-interval
Parameters
None
Default
The default is 0 seconds.
Command Mode
Router OSPFv3 Config
8-84
external-lsdb-limit (OSPFv3)
Configures the external LSDB limit for the OSPF. If the value is set to -1, then there will be no limit. A
router enters the overflow state when the number of non-default AS-external-LSAs in the router’s link-
state database reaches the external LSDB limit. The router will never hold more than the external LSDB
limit of non-default AS-external-LSAs in its database. Please note that the external LSDB limit in all
routers attached to the OSPF backbone and/or any regular OSPF area MUST be set identically.
The
no
command configures the default external LSDB limit for the OSPF.
external-lsdb limit -1-2147483647
no external-lsdb limit
