5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
778
Default
The default is None.
Command Mode
•
Privileged EXEC
•
User EXEC
Example
The following shows example CLI display output for the command when the OSPF Admin Mode is
disabled.
(Routing)#show ip ospf interface 0/1
IP Address....................................... 0.0.0.0
Subnet Mask...................................... 0.0.0.0
Secondary IP Address(es).........................
OSPF Admin Mode.................................. Disable
OSPF Area ID..................................... 0.0.0.0
OSPF Network Type................................ Broadcast
Router Priority.................................. 1
Retransmit Interval.............................. 5
Hello Interval................................... 10
Dead Interval.................................... 40
LSA Ack Interval................................. 1
Transmit Delay................................... 1
Authentication Type.............................. None
Metric Cost...................................... 1 (computed)
Passive Status................................... Non-passive interface
OSPF Mtu-ignore.................................. Disable
Flood Blocking................................... Disable
OSPF is not enabled on this interface.
Display Parameters
IP Address
IP address for the specified interface.
Subnet Mask
Mask of the network and host portion of the lP address for the OSPF
interface.
Secondary IP Address(es)
Secondary IP addresses if any are configured on the interface.
OSPF Admin Mode
States whether OSPF is enabled or disabled on a router interface.
OSPF Area ID
OSPF Area ID for the specified interface.
OSPF Network Type
Type of network on this interface that the OSPF is running on.
Router Priority
Number representing the OSPF Priority for the specified interface.
Retransmit Interval
Number representing the OSPF Retransmit Interval for the specified
interface.
Hello Interval
Number representing the OSPF Hello Interval for the specified interface.