5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
1097
(Routing)(Config-router)#neighbor 172.20.2.2 inherit peer AGGR
(Routing)(Config-router)#address-family ipv6
(Routing)(Config-router)#neighbor 172.20.1.2 activate
(Routing)(Config-router)#neighbor 172.20.2.2 activate
11-103 update-source
Use this command in Peer Template Configuration mode to configure a peer template to use a specific IP
address as the source address for the TCP connection with a neighbor. This IP address must be the IP
address configured on the peer as its neighbor address for this router.
Use the
no
command to configure the peer template to use the primary IPv4 address on the outgoing
interface to the neighbor for the TCP connection.
update-source {slot/port | vlan id}
no enable password
Parameters
slot/port
Specifies the slot/port of the source/interface to receive the routing
updates.
vlan id
Specifies the VLAN identifier for the interface.
update-source interface
The primary IPv4 address on this interface is used as the source IP
address for the TCP connection with the neighbor.
Default
The default is TCP connections (when an update source is not configured) use the primary IPv4 address
on the outgoing interface to the neighbor.
Command Mode
Peer Template Config
11-104 timers bgp
This command configures the keepalive and hold times that BGP uses for all of its neighbors.
When BGP establishes an adjacency, the neighbors agree to use the minimum hold time configured on
either neighbor. BGP sends KEEPALIVE messages at either 1/3 of the negotiated hold time or the
configured keepalive interval, whichever is more frequent.
The new values are not applied to adjacencies already in the ESTABLISHED state. A new keepalive or
hold time is applied the next time an adjacency is formed.
Use the
no
command to set to the default the keepalive and hold times that BGP uses for all of its
neighbors.
timers bgp keepalive holdtime
