5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
1055
ln IPv6 Address Family mode, this command controls the time between sending Update messages
containing IPv6 routes. D-LINK OS BGP enforces the advertisement interval by limiting how often phase
3 of the decision process can run for each update group. The interval applies to withdrawals as well as
active advertisements.
Use the
no
command to return to the default the minimum time that must elapse between advertisements
of the same IPv6 route to a given neighbor.
neighbor ip-address advertisement-interval seconds
no neighbor ip-address advertisement-interval
Parameters
ip-address
The neighbor's IPv4 address.
seconds
The minimum time between route adverfisement, in seconds. The range
is from 0 to 600 seconds.
Default
The default is as follows: 30 seconds for external and 5 seconds for internal peers.
Command Mode
IPv6 Address Family Config
11-49 neighbor connect-retry-interval
Use this command to configure the initial connection retry time for a specific neighbor. If a neighbor does
not respond to an initial TCP connection attempt, D-LINK OS retries three times. The first retry is after the
retry interval configured with neighbor connect-retry-interval. Each subsequent retry doubles the previous
retry interval. So by default, the TCP connection is retried after 2, 4, and 8 seconds. If none of the retries
is successful, the adjacency is reset to the IDLE state and the IDLE hold timer is started. BGP skips the
retries and transitions to IDLE state if TCP returns an error, such as destination unreachable, on a
connection attempt.
Issue this command in Peer Template Configuration Mode to add it to a peer template.
Use the
no
command to reset to the default the initial connection retry time for a specific neighbor.
neighbor {ip-address | ipv6-address [interface interface-name] | autodetect interface interface-
name} connect-retry-interval retty-time
no neighbor ip-address connect-retry-interval
Parameters
ip-address
The neighbor’s IP address.
ipv6-address
The neighbor’s IPv6 address.
interface interface-name
(Optional) If the neighbor’s IPv6 address is a link local address, the local
