5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
1003
10-21 show ipv6 pim neighbor
Shows the PIM neighbors discovered by PlMv2 Hello messages. The
slot/port
argument corresponds to
either a physical routing interface or to a VLAN routing interface. The keyword
VLAN
is utilized, instead of
the
slot/port
format, to directly specify the VLAN ID of the routing VLAN. If the interface number is not
specified, then the command shows the neighbors discovered for all the PIM-enabled interfaces.
show ipv6 pim neighbor [{slot/port | vlan 1-4093}]
Parameters
slot/port
(Optional) Indicates an interface in slot/port format.
vlan
(Optional) Indicates an interface in VLAN format (1-4093).
Default
The default is None.
Command Mode
•
Privileged EXEC
•
User EXEC
Example
The following is an example of the CLI display output for the command.
(Routing)#show ipv6 pim neighbor
Neighbor Addr
Interface
Up Time
Expiry Time
DR Priority
hh:mm:ss
hh:mm:ss
-------------------------
----------
----------- ------------
------------
fe80::200:52ff:feb7:58ac
0/21
00:00:03
00:01:43
0 (DR)
The following message will be displayed if no neighbors have been learned by any of the interfaces.
No neighbors are learnt on any interface.
Display Parameters
Neighbor Addr
The IPv6 address of the PIM neighbor on an interface.
Interface
slot/port
Up Time
The time since this neighbor has become active on this interface.
Expiry Time
Time remaining for the neighbor to expire.
DR Priority
The DR Priority configured on this Interface (PIM-SM only).
Note:
DR Priority is applicable only when sparse-mode configured
routers are neighbors. Otherwise, NA is displayed in this field.
