5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
94
excluded
Indicates the excluded tree.
Default
The default is as follows: views are created to grant access to the default group.
Command Mode
Global Config
4-108 snmp-server v3-host
This command is used to configure the traps to be sent to the specified host.
snmp-server v3-host host-addr username {traps | informs [timeout seconds] [retries retries]}
{auth | noauth | priv] [udpport port] [filter filtername]}
Parameters
host-addr
Indicates the IPv4 or IPv6 address of the host to which the trap or inform
notification is to be sent.
username
Indicates the user (characters: 1 to 30) utilized to send a trap or inform
notification. The user in question must be associated with a group that
supports the access method and version in question.
traps
Indicates that SNMP traps will be sent to the host. This option
constitutes the default option.
informs
Indicates that SNMP inform notifications to be sent to hosts.
timeout seconds
Indicates the number of seconds (default: 15 sec., range: 1 to 300 sec.)
that the system will wait for an acknowledgment before the inform
notification is resent.
retries retries
Indicates the number of times (default: 3 attempts, range: 0 to 255) that
an inform notification will be resent.
auth
Indicates that authentication is enabled but not encryption.
noauth
Indicates that no authentication or encryption is enabled. This option is
the default option.
priv
Indicates that authentication and encryption are enabled.
udpport port
Indicates the SNMP Trap receiver port (default: port 162).
filter filtername
Indicates the filter name (characters: 1 to 30) that is to be associated
with the host in question. Filters can be utilized to specify which traps
will be sent to the host.
Default
The default is as follows: views are created to grant access to the default group.
