5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
646
assigned the original default distance. The new default distance will only be applied to static routes
created after invoking the
ip route distance
command.
No
command sets the default static route preference value in the router. Lower route preference values
are preferred when determining the best route.
ip route distance 1-255
no ip route distance
Parameters
None
Default
The default is 1.
Command Mode
Global Config
7-26
ip route net-prototype
Add net prototype IPv4 routes to the hardware.
No
command deletes all the net prototype IPv4 routes added to the hardware.
ip route net-prototype prefix/prefix-length nexthopip num-routes
no ip route net-prototype prefix/prefix-length nexthopip num-routes
Parameters
prefix/prefix-length
Destination network and mask for route.
nexthopip
Next-hop ip address. It must belong to an active routing interface, but
does not need to be resolved.
num-routes
Number of routes needed to add into hardware starting from the given
prefix argument and within the given prefix-length.
Default
The default is None.
Command Mode
Global Config
7-27
ip netdirbcast
