Brocade Communications Systems Network Advisor 12.3.0, User Manual

Page: 885 / 1940

Brocade Network Advisor SAN User Manual 833
53-1003154-01
Configuring encrypted tape storage in a multi-path environment
20
Configuring encrypted tape storage in a multi-path environment
This example assumes one host is accessing one storage device using two paths:
•
The first path is from Host Port A to Target Port A, using Encryption Engine A for encryption.
•
The second path is from Host Port B to Target Port B, using Encryption Engine B for encryption.
Encryption Engines A and B are in switches that are already part of Encryption Group X .
The following procedure is used to configure this scenario using the Management application.
1. Configure Host Port A and Target Port A in the same zone by selecting Configure > Zoning from
the Management application main menu.
2. Configure Host Port B and Target Port B in the same zone by selecting Configure > Zoning from
the Management application main menu.
3. Select Configure > Encryption from the menu task bar to display the Encryption Center
dialog box (Refer to Figure 266 on page 694).
4. Click View Groups to display the encryption groups if groups are not already displayed.
5. Select Encryption Group X , then click the Targets icon.
6. From the Encryption Targets dialog box, click Add to open the Configure Storage Encryption
wizard. Use the wizard to create a target container for Encryption Engine A with Target Port A
and Host Port A.
7. Repeat Step 6 to create a target container for Encryption Engine B with Target Port B and
Host Port B.
Up to this point, the Management application has been automatically committing changes as
they are made. The targets and hosts are now fully configured; only the LUN configuration
remains.
8. In the Encryption Targets dialog box, select Target Port A, click LUNs, then click Add. Select the
LUNs to be encrypted and the encryption policies for the LUNs.
9. In the Encryption Targets dialog box, select Target Port B, click LUNs, then click Add. Select the
LUNs to be encrypted and the encryption policies for the LUNs, making sure that the
encryption policies match the policies specified in the other path.
10. Click Commit to make the LUN configuration changes effective in both paths simultaneously.
The Management application does not automatically commit LUN configuration changes. You must
manually commit any LUN configuration changes, even in non-multi
- path environments.
Committing LUN configuration changes manually allows the matching changes made in a
multi-path environment to be committed together, preventing cases where one path may be
encrypting and another path is not, thus causing corrupted data.
NOTE
There is a limit of 16 uncommitted tape LUN configuration changes. When adding more than 8 LUNs
in a multi-path environment, repeat step 8 and step 9 above, adding only 8 LUNs to each target
container at a time. Each commit operation will commit 16 LUNs, 8 in each path.