Brocade Communications Systems Network Advisor 12.3.0, User Manual

Page: 867 / 1940

Brocade Network Advisor SAN User Manual 815
53-1003154-01
Configuring encryption storage targets
20
6. Select a target from the list. (The Target Port WWN and Target Node WWN fields contain all
target information that displays when using the nsShow command.) You can also enter WWNs
manually, for example, to specify a target that is not on the list.
7. Select a target type from the Type list, then click Next.
The Select Hosts dialog box displays. (Refer to Figure 371 .) You can configure hosts for
selected target device ports. All hosts that are in the same fabric as the encryption engine are
listed.
NOTE
The selected target and initiator port must be in the same zone, or an error will result.
FIGURE 371
Select Hosts dialog box
The dialog box contains the following information:
•
Hosts in Fabric table: Lists the available hosts in the fabric.
•
Selected Hosts table: Lists the hosts that have been selected to access the target.
•
Port WWN: The world wide name of the host ports that are in the same fabric as the
encryption engine.
•
Node WWN: The world wide name of the host nodes that are in the same fabric as the
encryption engine.
•
Port Name: The user-assigned port name, if one exists; otherwise, the symbolic port name
from the device.
•
Port ID: The 24-bit Port ID of the host port.
•
VI Port WWN: The world wide name of the virtual initiator port.
•
VI Node WWN: The world wide name of the virtual initiator node.
•
Host Name: The name of the hosts that are in the same fabric as the encryption engine.
•
Port WWN text box: Type a world wide name for a host port.