Brocade Communications Systems Network Advisor 12.3.0, User Manual

Page: 1294 / 1940

1242 Brocade Network Advisor SAN User Manual
53-1003154-01
Adding a configuration policy manager
31
•
To configure the frequency, click the ellipsis button and choose one of the following
options to configure the frequency at which deployment runs for the configuration policy
manager:

To configure deployment to run only once, refer to “Configuring a one-time
configuration policy manager schedule” on page 1246.

To configure hourly deployment, refer to “Configuring an hourly configuration policy
manager schedule” on page 1246.

To configure daily deployment, refer to “Configuring a daily configuration policy
manager schedule” on page 1246.

To configure weekly deployment, refer to “Configuring a weekly configuration policy
manager schedule” on page 1247.

To configure monthly deployment, refer to “Configuring a monthly configuration policy
manager schedule” on page 1247.
6. To set configuration policy managers for fabrics, select the Fabric Checks tab and complete the
following steps.
a. Select the Check zoning status check box to determine if zoning is enabled or disabled on
the fabric.
•
Select the Enabled option to determine if zoning is enabled.
•
Select the Disabled option to determine if zoning is disabled.
For more information about this check and a fix for rule violations, refer to “Fabric policy
monitors” on page 1232.
b. Select the Check that all zones belong to at least one zone config check box to determine
if there are orphaned zones in the fabric zone database.
For more information about this check and a fix for rule violations, refer to “Fabric policy
monitors” on page 1232.
c. Select the Check the number of initiator ports zoned to each storage port check box to
determine the total number of initiator ports zoned to each storage port.
For more information about this check and a fix for rule violations, refer to “Fabric policy
monitors” on page 1232.
d. Select the Check zones that do not contain any online member check box to identify zones
in which all zone members are offline.
For more information about this check and a fix for rule violations, refer to “Fabric policy
monitors” on page 1232.
e. Enter the initiator port limit in the Initiator Port Limit field.
The default recommended threshold ratio is 1:1 (1 initiator port to 1 target port).
Therefore, if the ratio for the storage port is equal to or higher than 1:1, the configuration
policy manager considers it as a violation and logs it in the report.
f. Select the fabrics to which you want to apply this policy in the Available Fabrics list and
click the right arrow button.
NOTE
You can use the All Fabrics target in the Available Fabrics list for future provisioning. Select
All Fabrics and click the right arrow button to apply this policy to all discovered fabrics.