Atmel SAM9X25, Manual

Page: 914 / 1145

914
11054A–ATARM–27-Jul-11
SAM9X25
914
11054A–ATARM–27-Jul-11
SAM9X25
Example of bit timing determination for CAN baudrate of 500 Kbit/s:
MCK = 48MHz
CAN baudrate= 500kbit/s => bit time= 2us
Delay of the bus driver: 50 ns
Delay of the receiver: 30ns
Delay of the bus line (20m): 110ns
The total number of time quanta in a bit time must be comprised between 8
and 25. If we fix the bit time to 16 time quanta:
Tcsc = 1 time quanta = bit time / 16 = 125 ns
=> BRP = (Tcsc x MCK) - 1 = 5
The propagation segment time is equal to twice the sum of the signal’s
propagation time on the bus line, the receiver delay and the output driver
delay:
Tprs = 2 * (50+30+110) ns = 380 ns = 3 Tcsc
=> PROPAG = Tprs/Tcsc - 1 = 2
The remaining time for the two phase segments is:
Tphs1 + Tphs2 = bit time - Tcsc - Tprs = (16 - 1 - 3)Tcsc
Tphs1 + Tphs2 = 12 Tcsc
Because this number is even, we choose Tphs2 = Tphs1 (else we would choose
Tphs2 = Tphs1 + Tcsc)
Tphs1 = Tphs2 = (12/2) Tcsc = 6 Tcsc
=> PHASE1 = PHASE2 = Tphs1/Tcsc - 1 = 5
The resynchronization jump width must be comprised between 1 Tcsc and the
minimum of 4 Tcsc and Tphs1. We choose its maximum value:
Tsjw = Min(4 Tcsc,Tphs1) = 4 Tcsc
=> SJW = Tsjw/Tcsc - 1 = 3
Finally: CAN_BR = 0x00053255
CAN Bus Synchronization
Two types of synchronization are distinguished: “hard synchronization” at the start of a frame
and “resynchronization” inside a frame. After a hard synchronization, the bit time is restarted
with the end of the SYNC_SEG segment, regardless of the phase error. Resynchronization
causes a reduction or increase in the bit time so that the position of the sample point is shifted
with respect to the detected edge.
The effect of resynchronization is the same as that of hard synchronization when the magnitude
of the phase error of the edge causing the resynchronization is less than or equal to the pro-
grammed value of the resynchronization jump width (t
SJW
).
When the magnitude of the phase error is larger than the resynchronization jump width and
• the phase error is positive, then PHASE_SEG1 is lengthened by an amount equal to the
resynchronization jump width.
• the phase error is negative, then PHASE_SEG2 is shortened by an amount equal to the
resynchronization jump width.