Atmel SAM9X25, Manual

Page: 388 / 1145

388
11054A–ATARM–27-Jul-11
SAM9X25
388
11054A–ATARM–27-Jul-11
SAM9X25
29.9.3.3 Write Cycle
The write_cycle time is defined as the total duration of the write cycle, that is, from the time
where address is set on the address bus to the point where address may change. The total write
cycle time is equal to:
NWE_CYCLE = NWE NWE NWE_HOLD
= NCS_WR NCS_WR NCS_WR_HOLD
All NWE and NCS (write) timings are defined separately for each chip select as an integer num-
ber of Master Clock cycles. To ensure that the NWE and NCS timings are coherent, the user
must define the total write cycle instead of the hold timing. This implicitly defines the NWE hold
time and NCS (write) hold times as:
NWE_HOLD = NWE_CYCLE - NWE_SETUP - NWE_PULSE
NCS_WR_HOLD = NWE_CYCLE - NCS_WR_SETUP - NCS_WR_PULSE
29.9.3.4 Null Delay Setup and Hold
If null setup parameters are programmed for NWE and/or NCS, NWE and/or NCS remain active
continuously in case of consecutive write cycles in the same memory (see
Figure 29-13 ). How-
ever, for devices that perform write operations on the rising edge of NWE or NCS, such as
SRAM, either a setup or a hold must be programmed.
Figure 29-13. Null Setup and Hold Values of NCS and NWE in Write Cycle
29.9.3.5 Null Pulse
Programming null pulse is not permitted. Pulse must be at least set to 1. A null value leads to
unpredictable behavior.
NCS
MCK
NWE,
NWR0, NWR1,
NWR2, NWR3
D[31:0]
NWE_PULSE
NCS_WR_PULSE
NWE_CYCLE
NWE_PULSE
NCS_WR_PULSE
NWE_CYCLE
NWE_PULSE
NCS_WR_PULSE
NWE_CYCLE
A
[25:2]
NBS0, NBS1,
NBS2, NBS3,
A0, A1