Atmel SAM9X25, Manual

Page: 119 / 1145

119
11054A–ATARM–27-Jul-11
SAM9X25
119
11054A–ATARM–27-Jul-11
SAM9X25
14.5.2 Reset Controller Status Register
Name: RSTC_SR
Address: 0xFFFFFE04
Access: Read-only
• URSTS: User Reset Status
0 = No high-to-low edge on NRST happened since the last read of RSTC_SR.
1 = At least one high-to-low transition of NRST has been detected since the last read of RSTC_SR.
• RSTTYP: Reset Type
Reports the cause of the last processor reset. Reading this RSTC_SR does not reset this field.
• NRSTL: NRST Pin Level
Registers the NRST Pin Level at Master Clock (MCK).
• SRCMP: Software Reset Command in Progress
0 = No software command is being performed by the reset controller. The reset controller is ready for a software command.
1 = A software reset command is being performed by the reset controller. The reset controller is busy.
31 30 29 28 27 26 25 24
– – – – – – – –
23 22 21 20 19 18 17 16
– – – – – – SRCMP NRSTL
15 14 13 12 11 10 9 8
– – – – – RSTTYP
7 6 5 4 3 2 1 0
– – – – – – – URSTS
RSTTYP Reset Type Comments
0 0 0 General Reset Both VDDCORE and VDDBU rising
0 0 1 Wake Up Reset VDDCORE rising
0 1 0 Watchdog Reset Watchdog fault occurred
0 1 1 Software Reset Processor reset required by the software
1 0 0 User Reset NRST pin detected low